Gel promoting complete polymerisation of dental composites.

INOX protects the surface of composites by blocking oxygen access during the light-curing process. In this way, an inhibition layer does not form on the composite surface, so that the polymerization process is not inhibited and can proceed properly.

INOX Gel is intended for use during:
– polymerisation process of light-hardened composites;;
– prosthetic treatments performed with the use of dental cement (i.e. placing veneers, inlays, onlays), in order to promote complete polymerisation of composites.

INOX can also be used as a try-in gel for cementing of prosthetic works.

Ingredients:

  • propanotriol (glycerol), Ph Eur purified water, gel base

Available packages:

  • syringe of 2 ml + set of disposable applicators
  • MEGA PACK 4x syringe of 2 ml + set of disposable applicators

Description

Properties of INOX

INOX Gel makes the polymerized composite:

• HARDER – fully polymerized
• SMOOTHER – better prepared for finishing
• MORE DURABLE – more scratch- and abrasion-resistant
• MORE AESTHETIC – less susceptible to discoloration

The light of a polymerisation lamp penetrates through the gel layer. The product is easily washed out with water.

Handling the product INOX:

Polymerisation of light-cured composites:
1. Apply and form the last composite coat (Pic. 1), apply INOX Gel without touching the composite coat with the applicator.
The gel layer must tightly cover the whole surface of the dental restoration and stay in place during the polymerisation process (Pic. 2).
2. Light cure through the gel coat (Pic. 3).
3. Wash out INOX Gel after the polymerisation process has been finished (Pic. 4).
4. Trim and polish the composite surface as needed.

During seating of prosthetic works with resin cement:
1. When the restoration has been seated, remove excess resin cement as needed (Pic. 1).
2. Apply the INOX Gel on the marginal area of the restoration (veneer, inlay, onlay) without touching the composite coat with the applicator. The gel layer must tightly cover the whole surface of the dental restoration and stay in place during the polymerisation process (Pic. 2).
3. Light cure through the gel coat (Pic. 3).
4. Wash out INOX Gel after the polymerisation process has been finished (Pic. 4).
5. Trim and polish the composite surface as needed.

FOR PROFESSIONAL DENTAL USE ONLY

Gutaperka stomatologia
narzędzia stomatologiczne Cerkamed